Yes, every trailer that has the pre-existing wiring for the Furrion Vision S, like # FOS05TASF that you referenced, powers the camera via the running light circuit. So, you will need to have the trailer wiring hooked up to your tow vehicle and the headlights on to power the camera.
The only exceptions to this are when people make their own connections to a different power source. view full answer...
To manually extend the jack on the Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System part # LC358590 you will need to rotate the crank clockwise from the top of the motor using a 3/8" ratchet and extension. You will not use a socket for this position. Turning it to the right will extend it and left will retract it for you. view full answer...
The Lippert Ground Control 3.0 # LC675817 is designed to level your trailer so all of the jacks might end up being on different settings depending on where you're parked at any given time.
The system is smart enough to prevent you from over-operating the unit so it's basically whatever gets your trailer level are the acceptable numbers. view full answer...
For the Curt Rota-Flex 5th Wheel Pin Box # LC176440, Curt recommends to reuse the old hardware that was removed from the original pin box, unless they are damaged or unusable.
The torque spec is dictated by the type of bolt that is used along with the type of metal it is made of. For example, if you have 1/2"-13 grade 5 zinc plated bolts, then the proper torque spec is, 65 ft-lbs.
I have attached a chart that expands upon this, provided by Curt. view full answer...
To measure an RV shower pan you're just going to need to measure to the outside edge as if it were a square since these tend to be oddly shaped.
I have attached a diagram of a shower pan similarly shaped to the Better Bath 34" x 34" Neo Angle RV Shower Pan - Center # LC209795 for you to check out. view full answer...
The Solera 12V XL Power RV Awning # LCV000334966-362243 is going to include the brackets. It is recommended that you replace your current brackets with the ones included in order to be sure of fitment and it allows you to be sure that all of your components are in good working order.
I can not verify if the # LCV000334966-362243 would fit in your current brackets. I did reach out to the manufacturer to see if they could give me some insight one way or another but have not received a response.... view full answer...
The Camco RV Power Defender Voltage Protector - 50 Amp Item # CAM55306 is designed to sacrifice itself if it's hit with 2800 or more joules of power (i.e. lightning strike). So yes, if it was hit with a strong enough power surge it would be done. view full answer...
Go To Results